Where is the 2014 Jeep Compass Thermostat Located? An Easy Guide to Finding It

The thermostat in the 2014 Jeep Compass is located underneath the plastic intake manifold on top of the engine.

2014 Jeep Compass Thermostat Location

If you need to know where to find the 2014 Jeep Compass’ thermostat, you’ve come to the right place. Fortunately, the process of locating the thermostat on a 2014 Jeep Compass is relatively simple and straightforward.

The 2014 Jeep Compass’ thermostat is located in the engine compartment on a cylinder-shaped housing. It’s typically situated near the top of the engine block and is made of a black composite material. Additionally, this component is operational only when your car engine is running.

To access your Jeep Compass’ thermostat, you may need to use additional components such as brackets or clips; however, in most cases no tools are required. Be sure to have some cloth gloves handy before starting this procedure; they provide much-needed protection from any hot surfaces you may encounter during diagnostics and repairs.

To ensure that your journey runs smoothly with minimal hassles, it’s important that you consult an experienced mechanic if you have any questions or queries regarding the location or maintenance of your 2014 Jeep Compass’ thermostat.

Overview

The 2014 Jeep Compass has a thermostat that is located in the engine bay, near the radiator. This thermostat is responsible for regulating the temperature of the engine’s coolant system and is an important part of keeping your vehicle running properly. In this article, we’ll take a look at how to locate and change the thermostat on a 2014 Jeep Compass.

Locating the Thermostat

The first step in changing the thermostat on a 2014 Jeep Compass is to locate it. The thermostat can be found in the engine bay, near the radiator. It will be a small metal box with two hoses attached to it. These hoses are attached to the coolant system, which circulates coolant throughout the engine block and radiator.

Removing The Thermostat

Once you have located and identified the thermostat, you can begin removing it from the vehicle. Start by disconnecting the two hoses from either side of the thermostat housing. Next, use an appropriate sized wrench or socket to loosen and remove any bolts that are holding it in place. Once these bolts have been removed, you can carefully pull out the old thermostat from its housing.

Installing The New Thermostat

Now that you have removed your old thermostat, you are ready to install your new one. Start by lining up your new thermostat with its housing and then insert it into place. Make sure that it is seated firmly before proceeding any further. Once it is properly seated in its housing, re-attach both of its hoses securely before moving on to tightening down any bolts that were removed earlier.

Testing The New Thermostat

Once you have finished installing your new thermostat, you should start up your engine and allow it to reach normal operating temperature before performing any further tests or adjustments on it. This will allow you to ensure that your new thermostat is working properly and regulating coolant temperatures correctly before closing up everything again.

Introduction

The 2014 Jeep Compass is a popular SUV model. It is equipped with an engine cooling system that includes a thermostat. The thermostat helps regulate the temperature of the engine so it can run efficiently and safely. Knowing the location of this component can be useful in a variety of situations, such as when you’re performing maintenance or troubleshooting an issue with your vehicle. In this article, we’ll discuss the 2014 Jeep Compass thermostat location and how to access it for repair or replacement.

Location of the Thermostat

The thermostat on the 2014 Jeep Compass is located on the driver’s side of the engine bay near the top of the engine block. It is directly behind the coolant recovery tank, which can be identified by its blue plastic cap. The thermostat housing should have two hoses connected to it: one coming from above and one coming from below.

Accessing the Thermostat

Once you have located the thermostat, you can begin to access it for repair or replacement. First, you’ll need to remove any components that might be blocking access to it, such as hoses or wiring harnesses. Once these are out of the way, you should be able to gain access to all four bolts that hold the thermostat in place.

Removing and Replacing The Thermostat

Once you have gained access to all four bolts, you can remove them using a socket wrench and then remove the thermostat from its housing. To install a new one you will need a new gasket and O-ring set as well as some RTV gasket maker sealant. Once everything is in place, reinstall all four bolts and tighten them evenly with a torque wrench until they are snug but not overly tight. Finally, reattach any hoses or wiring harnesses that were removed earlier and refill your cooling system with fresh coolant before starting your vehicle again.

FAQ & Answers

Q: Where is the thermostat located on a 2014 Jeep Compass?
A: The thermostat on a 2014 Jeep Compass is located in the engine bay, usually near the top of the engine towards the passenger side.

Q: How do I access the thermostat?
A: To access the thermostat on a 2014 Jeep Compass, you will need to remove the intake manifold and other components blocking its location. This can be done by unscrewing them and then carefully pulling them away from the engine.

Q: What should I do once I have access to the thermostat?
A: Once you have access to the thermostat, you can either replace it or inspect it for any signs of wear and tear. If replacing, make sure to use an OEM-specification part as aftermarket parts may not fit properly.

Q: How difficult is it to replace a 2014 Jeep Compass Thermostat?
A: Replacing a 2014 Jeep Compass Thermostat is not overly challenging for someone with some mechanical experience. It requires some disassembly of components before reaching the thermostat, but once that’s done it’s simply a matter of removing old part and installing new one.

Q: Are there any safety precautions I should take when working on my 2014 Jeep Compass thermostat?
A: Whenever working on any part of your vehicle, you should take caution to ensure your safety as well as that of your vehicle. Make sure to wear protective gear such as gloves and eye protection when working with fluids or small parts. Additionally, always disconnect battery power before beginning work so as to avoid any potential electrical shocks or shorts.

The 2014 Jeep Compass thermostat is located on the left side of the engine compartment. The easiest way to access it is to remove the air filter housing and locate the thermostat housing beneath it. Be sure to check your engine’s service manual for more detailed instructions on how to properly change the thermostat.